OT---Opinion wanted concerning servce interval.

Jiles

Well-known Member
I believe a person should service a machine according to manufacturer suggestions with the products they recommend.
I have a new ZD221 Kubota zero turn mower. My owners manual states that the engine oil and filter MUST be changed at 50 hours and therafter every 200 hours. They further recommend that in unusually dusty or wet conditions that this service be done at one half the recommended hours.
This seems to be an excessivly long service interval to me, even though it has a three cylinder diesel engine.
I plan to service the machine at 20 hours and at 50-75 hours therafter.
I just wanted to hear your opinions.
 
I would leave the factory oil the 50 hours.

It may have, but possibly not have, something special about it.

100 hours is often enough. 50-75 seems excessive to me.

If you put less than 100 a year on it I would change it every year.
 
I've seen tractors that didn't break-in because the break-in oil was taken out too soon. Changing oil every 100 hrs should be often enough provided you don't take over a year to get 100 hrs.
 
As a professioal mechanic all I can say is that, by doing what you suggest, you are more than welcome to waste your money if you want. Mfg intervals are based on a specific set of parameters using a specific oil/grease. If you use a better quality oil/grease than you can prolong the intervals, if you use a lower quality oil/grease then you need shorter service intervals.

I know, I know alot of people, many of them on here, will tell you that "All oils and greases are the same". A little research will show that to be wrong because, in fact, there is a big difference between the 'cheap' stuff, the 'regular' stuff and the 'really good' stuff.


Case in point we have a customer that was using grease X on their crane and we finally convinced them to use grease Y. Within a month, using the better grade grease, they were able to cut the greasing intervals in half and after a while using that interval and seeing the results they were extending the interval even further because the better grease actually staid where it was put.

They had resisted the better quality grease in the beginning because it was a little more expensive than the "regular" qualiy stuff. In the end by being able to extend the intervals they actually saved money on the more expensive grease because they had to apply less of it over a greater perioe of time.

As far as oil, the "base oil" isn't what wears out, it stays oil, what happens is that the additives in the oil that make it work like it's supposed to (ie-act as a multigrade oil, make soot particles stick together so they'll filter easier, prevent varnish, etc) then the oil is going to be good no matter how long it's in the engine. In other words if you use a better quality oil with a better additive package than the 'regular' stuff then by virtue of that you'll actually get a longer life out of it before it needs to be changed. By the same token use a 'cheap' oil and you will need to change it more often.

Like I said do whatever you want but with a little research I'll guarantee you that you can actually extend the life of the oil and the components of your machine and in the end save alot of money by spending a little more money for 'the good stuff' instead if simply shortning the factory intervals and costing yourself more money.....but that's just my .02 based....
 
On my Yammer diesels(yes more than one ) I change every spring and they will have right at 100hr on them. 200 hr mowing grass is a lot of personal yard,at one time I was mowing 9ac total on three diferant places and put on 225hr per year.(60inch deck)
 
We used some German made grease at work, in high speed machine spindles, we called it uberlube. Darn stuff doubled the service life on some bearings. Mgt didn't like it, it was $100 per tube.
 
As I rember it in a Ford tractor manual it stated. Change oil every 50 hrs.This could figure out to once a week if you had alot of field work. Change filter every 100 hrs. This was in the mid 1950's

I changed oil and filter every spring.

steveormary
 
I change mine once a year in my 1715 N/H. That is about 60 HRS. I figure the price of Oil and Filter is cheaper than An engine.
 
'course, if you have a tractor like the MD my grandpa had, you'd add a gallon after a day's work, between the leaks and what burns... so you're basically changing oil every week just to keep it full... ;-)
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top