was wondering if anyone here has experience with a plasma cutter? What happens when you hit a spot of rust or dirt? Thanks Iron
 
The only issue is if the encountered material is an inclusion or scale that is way different in composition. Then it might deflect the "plasma jet" and cause roughness in the cut.
However on some CNC controlled machines, the offset for tip to work is affected by a secondary current through work to tip. This distance can vary over insulated material, and allow a fail to start condition, if at the beginning of a pierce point. JimN
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top