perfect easy out.

[UncleTom]

Again I had to drill something out. This time it was a main jet in a small engine carburetor. I use a torx bit of appropriate size. Drove it in and it comes right out.this was o ly brass but have used it on steel. It is amazing.

 

[drummer481]

I will remember that...........thanks

 

[DaleinWV]

a good recommendation - thank you

 

[SDE]

I pounded a 12 mm onto a rounded off 1/2'' hex. I was proud myself until the side of the wrench cracked. Oh Well, a little welding and the wrench will be usable again.

 

[Texasmark]

Me too!

 

[Caryc]

(quoted from post at 19:19:27 09/06/22) I pounded a 12 mm onto a rounded off 1/2'' hex. I was proud myself until the side of the wrench cracked. Oh Well, a little welding and the wrench will be usable again.

Situations like that is where this Metrinch set comes in real handy. The sockets and wrenches work on the flats of a nut instead of the sharp corners. Even with bad rounded nuts, you'll always find a size that will work on it. There is no such thing as metric or SAE when using this set.

 

[Charles in Aus.]

They look like the Cat's pyjamas Carryc.

 

[47fivewindow]

like

 

[Caryc]

Here is a better pic of how they work. They'll also work on old square nuts.