because the air is thinner at higher altitudes,
so you need more space in the cylender to get
enough oxygen to run right

Id think highdome is where the surface of the
piston is higher then normal, crater is lower the
normal. Im assuming. Im sure someone will come up
with a better answer then this.
 
Good try Lanse! Almost correct. There is less air at altitude, but higher compression is needed not lower. All pistons Fire Crater, and others stick out above the deck of the cylinder. Taing up space in the combustion chamber. For lower compression (distillate) the combustion chamber was enlarged with different valves. As far as I know, on Gas farmalls none had depressions in them, they were flat topped or domed. JimN
 
Almost right Janicholson. Fire crater pistons for an engine without a combustion chamber in the head (head flat with valves heads lower than block deck) are only shallower than the regular crater pistons for higher compression. I think some Allis Chalmers tractors came out with what was called a fire crater and they really did not have a deeper cratered piston for the application.
 
Airflow depends on displacement which is bore X stroke. Compression ratio doesn't affect that.
To regain some of the power lost at high altitude.
A higher mechanical compression ratio of say 9 to 1 is used to obtain say a 150psi cranking pressure at 10,000ft.
A lower mechanical compression ratio of say 7 to 1 is used to obtain say a 150psi cranking pressure at sea level.
 
What everybody else said and . . . the FireCraters stem from an early design to optimize efficiency of the burn by reducing the piston interfering with the shape of the flame when the fuel lights off by leaving a depression in one part of the piston top (the crater).
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top