position control?

[Sweating in Florida]

I seen another question about the position control selector and remembered I have a problem with mine.
Put it in the up position, the position I think I should be using for bush hog work, and it just raises the lift arms up.
Not that I moved the quadrant to up, in fact I can put the quadrant in the down position but the arms still raise.
So I have been leaving the position lever in the draft mode. but the hog wants to drop deeper needing frequent adjustments.
Am I doing something wrong?

 

[Bruce (VA)]

Try adjusting using the quadrant adjustment (paragraph 151 of the I&T FO4 manual) If that doesn't work (and it probably won't) it's time to pull the top cover for internal adjustments & replacing the cam follower pin.
50 Tips

 

[Sweating in Florida]

Thanks Bruce I will give it a look at.

 

[Bruce (VA)]

If it doesn't work, post back for help w/ pulling the top cover, adjusting the linkage & replacing the cam follower pin. Many of us have done that.........more times than we'd like to remember!
50 Tips

 

[ZANE]

It sounds to me like you may have more than adjustment problems. Maybe the cam follower pin is completely worn off or something has come loose or broke etc.

I make a lift adjusting jig fixture with simple instructions and it comes with a new pin.

See the link below.

Zane
ZANES N LIFT STUFF