power reverser problems

Check the linkage down under the tractor, there's an adjustment you can make there. Probably just too much travel in one direction now. Check the pin while you're down there, it's just a cheap wire hairpin. Ours snapped. Kinda cold when it's -40 out and you're outside reaching up under the tractor with no coat on because your arms won't fit with sleeves on for 20 minutes to get the tractor going again.
 
with electronic reverser there is no linkage, its just a switch. i would start by checking forward clutch pressures, ive seen the sealing rings in the power quad housing worn out before causing that or it will modulate bad. another thought, check codes and see what you have. your software might need updated. is the actual reverser lever jumping out of the forward position? there might be a probelem with the detent solenoid and the switch might be bad.
 
the early 6320's had a different style shifter. seems to not last as long. There is an upgrade kit available. This happened to my 6320, 2002 model year just after I purchased the tractor. Luckily for me the dealer replaced it free of charge. The new shifter looks like the ones on the new tractors. Good luck!
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top