power shift problem

[runningbird-HT]

I have a FX22D that has developed a problem. The tractor can be running fine when all at once it stops moving. If you rev up the motor it may start again but it moves slowly and shifts are weak. Does not matter what gear you are in or if 4wd is engaged. I have cleaned the screen and put on a new hyd. Filter. Any ideas?

Thanks,
Mark

 

[Norm-HT]

I would buy a parts manual and see what looks likely to cause the failure, then "Inspect and repair as necessary".

 

[Aaron-HT]

There is a spring in the powershift valve body that breaks and causes this. Dont use it like that or you will burn up your clutch pack ($$$$.$$).

 

[runningbird-HT]

ok got it....how hard is this spring to get to. is it in the releife valve?
thanks
Mark.
I did email you with my email address.

 

[DAIRYMAN-HT]

Just replied to your ticket!

 

[runningbird-HT]

thanks for the help. I did pull that valve is the spring further in?
again thanks for the help!

 

[runningbird-HT]

OHHHHHH now I got it. in that valve was another tiny snap ring with a piston behind it, very little pressure, got the piston out and behind it was what was left of a spring, broke in about 8 pieces. hope hoye has the spring I need.
thanks Guys!