Power Steering test

550Doug

Member
Location
Southern Ontario
I picked up a used Eaton vane pump for a Cockshutt 540 (as well as the associated steering column), and I'm wondering if there is a way to test it before I go to the trouble of installing it? Can a rebuilder test it without disassembling?
 
I would go ahead and take it apart, clean it up, look it over. Just be very careful,take pictures, be sure to go back exactly as it came apart.

No telling what might be inside, you don't want to start out with a contaminated system. It helps if it was recently disassembled. But if it's been open and exposed to the elements...

If all looks good, replace the orings and seals. They can be bought online or matched at a bearing supply.

If you just don't want to go into it, flush it with clean solvent or diesel. Turn it through, see if it will pump. Getting a rebuilder involved will be very expensive. They would have to take it apart. The problem with using a rebuilder, they have to go back in perfect condition in order to stand behind it.

You, on the other hand, can do what you feel is necessary, it's your pump. If it's less than perfect and it doesn't work or leaks, then go back in, do whatever is in the budget.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top