Progress on 135 M/H

[Traper]

Pulled engine [3 cyl d]#3rod was nock shaft too bad to turn have to replace.Strange thing can not find serial # have it on engine stand block clean checked all machined flat spots.Any idea?Oil pan mark 1970 angle jnjector rope rear seal.
traper

 

[Tony in Mass.]

Is that all so far? One rod? Did it start to hydrolock or something? I got a Perkins 4 gas rod- off Ebay, from a very helpfull fellow with a machine shop in Ohio, he might have one you need, and Fawcett's in Ontario should have some on a shelf too. If you want their addresses, let me know.

 

[Traper]

Tony This engine has over 6000 hr needs rebuild but tractor was cheap will see if rod can be recondison has factory loader.traper

 

[dande man]

check out atis.net or type in[tractor salvage yards]
list for all states


Dan

 

[TXMF135]

You might try to call accurate engine in fort worth texas. I bought a new conn rod and he reconditioned my old one. He might still sell new in box rod to you if he hasn't sold it. For AD3.152 motor. His name is Rick 817/335-4483. He used to do Perkins motor service in the seventies.
Accurate website