pto problem ford 7000

kennyhatcher

New User
I have been working on a ford 7000 pto problem. the dp works fine and three pt works also I split the tractor and put in a new pto clutch
pack seem to work fine then when to use it and the dp on high made pto started turning put back on low side and baled about 80 small bale
started to make noise and found low on oil now the pto won't work when dp on high side don't have gauge to check psi
 
The dual power and the pto use the same low pressure oil system. There is an internal leak on the high side. Most likely in the area of the sealing rings on the direct drive clutch pack. If you just overhauled the pto clutch , then you would be familiar with the sealing rings on that. The direct drive dual power clutch pack is similar.
 
Well then... you better get a gauge. The 0-500 psi models will suffice. It needs to make 160-180 psi at a fast idle with warm oil. From your description it sounds like you have a leak somewhere in the system; possibly in the low side of the dual power.... but I would want to test it in all variations of it's function before making that determination. Could also be a leak on the supply tube or in the PTO clutch sealing rings... or a broad combination of all of the above...

Rod
 
Thank you. I split the tractor and put in a new gear and pto clutch assembly is there any adjustments for oil psi or valve control doesn't look like one ?????
 
we where working on are square baler today and only had the ford to get it out of the barn so we hooked up the pto just to help work the baler and the pto started then would't turn over at all. could that new clutch be shot already.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top