Pulley removal

[freefour]

Want to take this pulley off my old B. I think it's from a woods mower setup. I got the three 1/2" bolts out but nothing will budge. I'd though the I better ask before getting rough. Thanks.

 

[kevinj54]

Put em back into the puller holes.

 

[old]

There are 6 holes there. The 3 that the bolts where in are lock down bolt holes the other 3 are to removing the pulley so as the other guy said put the bolts in the other 3 holes and tighten them down and the pulley will loosen up

 

[khouse6]

make sure that the little bolts are in good shape, before you use them to remove the pulley. use new ones, if there is any doubt. do not ask why i
cautioned you about this.

 

[Bob M]

Put the bolts into the 3 tapped holes
on the hub flange, then tighten them
equally and evenly. The hub and pulley
will separate and slide off easily.

 

[wilson ind]

Clean puller threads with bottom tap.

 

[freefour]

Came off with ease. Thanks everyone!