question about 1070

[randyrenfro7]

I have a 1070 case. I have bought a bat wing bush hog and it has up and down for the rear wheel position. But the wings have a single port cylinder. How do I make that work with the dual remotes on the 1070? Help please.

 

[jon f mn]

Just plug it into one side or the other and it will work. When you lower it you can only move the lever part way to avoid going through the relief,but its not really necessary for a low use situation like that.

 

[J Hamilton]

Do as jon f mn says, I have an 1170 that I run a batwing mower with and that's how I do it as well.

 

[randyrenfro7]

Thanks guys, I'll give her a try.

 

[John Saeli]

I have a 1070 case. I have bought a bat wing bush hog and it has up and down for the rear wheel position. But the wings have a single port cylinder. How do I make that work with the dual remotes on the 1070? Help please.

Are you sure that they are not 2 way cyl's and the return port is simply not used? Our Bush Hog bat wing came plumbed as 1 way cyl's, but were in fact 2 way cyl's. I ran lines and plumbed them as 2 way. Do your hyd. system a favor and check it out.

 

[randyrenfro7]

I told myself I looked at it good and only saw one port, but the machine hasn't been delivered to me yet so I will look again very closely. Thanks John