R clutch

[b.eugene]

I don"t have a manual. Can anyone give me a quick rundown on tightening a R hand clutch? I also need a clutch spring. Where is a good place to find one.

 

[JOCCO]

There is a cover on the bell house and there is a ring with spring loaded pin turn it to adjust it.

 

[b.eugene]

Thanks. I see the pin. Do you stop the main housing from turning

 

[JOCCO]

I use two screw driver type tools one for pin one to turn the notced ring. Yes whole pressure plate can turn. Grease through out bearing while you are in there it should have a zerk. Just a few notches shouuld do it unless you have bad part. This set up was used on MM torque amplifiers and pto clutches too.