radiator repair

[johnn-HT]

I have a YM2000 and the radiator sprung a leak at the top seam. Can it be repaired by soldering or should it be brazed? is there a special antifreeze to use?

 

[SDgray-HT]

i have fixed seam leaks with solder and a propane torch-use a good plumbing flux to clean the brass in the repair area so the solder will flow and stick well.

 

[johnn-HT]

thanks for the heads up!

 

[winston-HT]

regular anitfreeze will work fine. brazing requires more heat, therefore it would melt the solder out in trying to use it. Cleanliness is the biggest key to a good solder job.

 

[alan-HT]

I'd take it to a rad shop, which will do it if possible and pressure-test. And if called for offer alternate solutions which will be cheaper than a new one if available, and more secure then a salvage one. If it leaks in one place it's unlikely the rest of it is fine.

 

[Carey-HT]

I Agree Alan. A Radiator repair shop would be the best way to go. It's just not worth it. Then keep the Antifreeze clean and it should last the Life of the Tractor. I know I had to flush and change my Radiator 2 or 3 of times the first Yr. I owned it. It's been over 5yrs. and haven't had any problems and it stays clean <E>:wink:</E>