Lynn Patrick
Well-known Member
I am in the process of rebuilding a terribly rusted out PA rim on my "new" 881. I have a new rim purchased & have 2 of the 4 "rails" off & cleaned, ready to weld on. My question: do any of you have a good way to remove & clean up these "rails"? I have used a 4" grinder w/thin metal cutting blades (it takes a LOT!), a panel cutting air gun (too wimpy!), a big grinder (to clean up the spot welds), and mostly a big hammer & chisel. I'm worn out & have 2 to go!! Any suggestions? How did you do it??
Thanks in advance!
Lynn
Thanks in advance!
Lynn