D13series2
Member
Allis B, chassis castings and engine were derusted, cleaned, and painted with rustoleum primer, TSC enamel with hardener 10 years ago. Sheet metal was stripped and Jasco pre& prime used to kill rust. Was never assembled. Parts are now dirty, paint that was with the tractor has set up. Paint on chassis is on well. Would like to finish this up but not happy with dry time and glass of Majic etc. Would suspect I would get better results out of acrylic urethane single step.
My current plan is to pull it out and wash it with mild soap (it's not greasy just dirty), scuff with maroon Scotchbrite, W&G cleaner, apply a sealer coat of epoxy primer, then paint inside the window (to avoid scuffing the sealer). On the other parts, rust repair if needed / possible, electrolysis on some of the delicate / rare stuff, sandblast remaining castings, phosphoric acid wipe followed by rinse and wash down. W&G remover, then epoxy prime and paint.
How's my plan?
My current plan is to pull it out and wash it with mild soap (it's not greasy just dirty), scuff with maroon Scotchbrite, W&G cleaner, apply a sealer coat of epoxy primer, then paint inside the window (to avoid scuffing the sealer). On the other parts, rust repair if needed / possible, electrolysis on some of the delicate / rare stuff, sandblast remaining castings, phosphoric acid wipe followed by rinse and wash down. W&G remover, then epoxy prime and paint.
How's my plan?