Ring Gear

[Nortex]

I found a decent flywheel for my 47 A, but may need to replace the ring gear. I understand the ring gear is easily removed with a little heat. Will a propane torch work for this job? Can anyone go over the process for heating the gear, removing it and putting it on another flywheel? Advice is appreciated.

 

[old popper]

You shouldn't need heat to remove the ring gear. An old dull chisel should get it started, just go around moving it a little at a time. As for re installation, a "kettle grill works perfectly for heating the ring gear and it should almost fall on. Be sure to get the bevel on the teeth the correct way.

 

[Nortex]

Thanks for the info. Sounds simple.