Destroked 450

Well-known Member
Location
Harned, Ky
Heading up to near Lancing, MI to pickup a tractor transmission and rear axle
We'll be traveling up I-65 out of Ky to Indianapolis and then I-69 to Lancing
Who will we be passing close to?
 
I live a few miles east of I65 just south of I465

I65 is closed in downtown Indianapolis, but the preferred route from I65 to I69 has always been around the east side of Indianapolis on I465. They have just begun to reconfigure the interchange between I69 and I 465 on the northeast side of Indianapolis. As far as I know northbound traffic is not affected yet. There may be delays for southbound traffic.
Construction Video
 
Im north of Indanapolis off 69 ,,exit 245... 15 mi west ,,, what do you like ,,, and like to see ?
 
IF it is closed and not in a big hurry go east to IN-9 and go north from I-40 not a bad little side trip. I use it when I come down to Greensburg for roofing. Custom Metal Sales right at the airport on us-40 I'm about 35 miles north east of Lansing 10 miles north of 69 Where are you going in Lansing? Just curious might even be able to give directions if needed.
 

I always take 465 around Indy, got lucky at Seymour, there was a wreck on the south bound side across from the truck scales, I65 was backed up solid for 7 miles
 
I'm about hour 20 west of Indy.
The problem is construction.
When there is construction, traffic backs up
and many times someone doesn't slow down.

One time I was on 465 west during rush hour.
A deer took out a car and 2 other cars rear ended the first car.
What a mess. I just missed the accident by seconds..deer parts
flying all over...
 
I just drove through Lansing to Indy through Louisville to Al. and back last week with my truck and
trailer with room on it. Too bad we couldn't have connected as I would have been able to probably
bring your stuff to you. I would have done it for a little gas money as it cost me 800 bucks in gas
to make the trip. Other than the gas bill it was a good trip and hopefully it will be the same for
you.
 
Located just east of Seymour, US-50. (Can you find Hayden?) We went to Lansing couple of weeks ago, empty gooseneck both ways. Helped a friend move some
equipment. From I-94 to Lansing was pretty rough. On the way home, we dropped down to Coldwater and went west to Sturgis (Michigan) and south on Indiana highway
9 to Columbus. We were not in a big hurry, but I also like to avoid Interstates when I can.
 
="Destroked 450"](quoted from post at 07:55:35 04/02/22)
Going just west of Lansing on I96 to Eagle exit then local roads to the guys house

You won't have to take the bypass around Eagle, drive right thru downtown.
But don't blink, you will miss it.
 
If you go west of Eagle on 96 to 66, I'm about 25 mules north. If you stop in, wear your boots. It's muddy everywhere.
 
Hayden!? I remember buying used truck parts there years ago. Helped me survive for several years when my times were really skinny!
 

Got back home a little after 4:00 pm today, sorry we didnt have time to stop by at anyones place, it was a get there, pickup the parts and get back trip
Did meet a really nice man and his son, the man said his dad use to have the Ford tractor dealership in Portland just a few miles from there
Scored some pretty good parts and even added some more to my load, well worth the trip
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top