Hey guys, rebuiding my z145 and got 3 questions.
1) The rod and main bearings have a manufacturers mark of MN. Can't seem to figure out what brand this is. Part numbers of 1750234M1 and 1751430M1 are the only marks on the bearings themselves. No size indicator at all. Believe these to be .010 overs based on measurements but would like confirmation. Never ran into a bearing that did not have size stamped on them, even factory ones..
2) The rear main has this string that needs to be packed in for the side seals. Is there any particular sealer that should be dripped in there as its packed down? The classic permatex brown gasket maker?
3) When i pulled the govener off one of the bearings fell out. Can i just crimp the cage a hair to hold it in or should i replace the govener?
1) The rod and main bearings have a manufacturers mark of MN. Can't seem to figure out what brand this is. Part numbers of 1750234M1 and 1751430M1 are the only marks on the bearings themselves. No size indicator at all. Believe these to be .010 overs based on measurements but would like confirmation. Never ran into a bearing that did not have size stamped on them, even factory ones..
2) The rear main has this string that needs to be packed in for the side seals. Is there any particular sealer that should be dripped in there as its packed down? The classic permatex brown gasket maker?
3) When i pulled the govener off one of the bearings fell out. Can i just crimp the cage a hair to hold it in or should i replace the govener?