rrlund

[jhwis]

Randy, the 1750 pto stub....

Yes it is a dual speed. Do you need a hydraulic press to press it out? I don't have one. Would you replace bearing also while it's out?

Also, it isn't worn bad, but i noticed my haybine pto splines I ran on it was worn pretty good. Upgraded to a discbine and didn't want to wear out the splines on its pto..... What say you?

jh

 

[rrlund]

I pressed one out. Don't know if you could knock it out without bunging up the bearing or not. I would imagine you could. I reused my bearing. I snapped one one time by sliding a worn shaft on to it. I bought an MC Rotary Scythe and the PTO yoke on it was worn bad. When I slid it on to where the pin would pop in to place,I only had a little bit of the yoke splines in the tractor PTO. The darned thing was set up and when I tried to start it with the splines just having ahold of the very tip of the shaft,it broke it right off at an angle.

 

[jhwis]

Thanks for the input.