run-away-engine

Finally got my engine back in my tractor after a rebuild. The last thing I did was rebuild the carb and fired it up.It started just fine but the engine kept accelerating. I pushed the throttle all the way up and it slowed down.When I let it go the engine ran up again. The throttle does not seem to be moving but the engine keeps going until I push up on the throttle again. Could this be a carb problem or is the u-bolt on the throttle rod not in the correct position? Any ideas on this problem? The tractor is a TO30. Thanks
 
Robert I will be interested to see what the real guys say but my guess would be it has something to do with the rod between the throttle and the governor not being hooked correctly. I haven't had this experience yet just thinking in my little brain what might be wrong. Good Luck Richard
 
I"ve never had this problem but it sounds like the governorlinkage and/or the throttle rod is not adjusted properly. The shop manual and the owners manual has the sdjustment procedure. Also the fricion disc on the throttle linkage may be worn and not holding the throttle in position
 
Robert, I agree with the other guys, go thru your carb linkages and adjust per the manual. It is a tedious process, but most likely where your problem is coming from.

George
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top