Runaway case 504

b.jones

Member
I log in everyday but have not posted in years. Still love Yamag. Went to start a 2470 case with a 504 that has been sitting outside for about 5 years. The push pull kill button was stuck but I got it loose . It felt ok. Primed the injection pump. I tried to start it 3 or 4 times maybe total cranking time of 15 seconds and it started. I know its got old fuel. Im thinking the governor is stuck because it revved pretty high. I quickly pulled the kill button. It seemed slow to act but died after about 5 seconds. Is there a way for me to free up the governor if that is the problem? There is a long plate on the side of the pump, I think held on with 2 bolts. Thanks for any help you might give.
 
You will probably get some answers here but you may have better luck asking this down on the CASE board. I sort of remember someone asking a similar question & If I remember correctly something is stuck in your pump.
 
It's NOT the governor, pump has one or more stuck plungers which keeps the rack from moving freely so governor can work. Old stale fuel is the cause, Bosch A size pumps can be checked for free rack movement before starting engine IF the front rack cap can be removed on engine. I just freed up some stuck plungers on a 1570 Bosch pump that did the same thing.
 
The rack can be stuck, happens sometimes. There is a round cap on the front with two flat sides that take a 3/4 wrench. Take the cap off a d see if the rack moves easy. So.e ery gentle working can sometimes free them. Otherwise you will need to get inside to clean and free them
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top