Same old, Same old. 6700 Ford PTO

Without belaboring previous inquiries, I had to replace the pto clutch pack (rebuilt not new)because the previous one was damaged when the transmission was put back in. The PTO quit turning after one of my guys baled 2 round bales. When I cranked the 6700 Saturday and engaged the PTO, it started turning slowly at first and then picked up. I got off the tractor and stood behind it and could hear a rattling noise behind the PTO. None of that makes me feel good. Any one have any idea what might be wrong now? The mechanic says it's the clutch pack but he also said he didn't mess up the clutch pack when he put the transmission back in. His credibility has wained with me in recent weeks.
 
Put a gauge on it and FIND THE LEAK. When you know where the leak is at, go from there.
Those PTO's have a certain rattle to them at idle so I wouldn't be too excited about that, but if the clutch plates are not properly seated there might be some additional strain on the rear thrust bearing.
Just find the leak first...

Rod
 
Rod is correct, a rattle is normal at idle. Not to worry if it goes away under a load.

The PTO was damaged when your mechanic put the tranny was put back in, whether he wants to admit it or not. I've seen too many of these screwed up to believe otherwise.
 
Yes, I beleive it did. If not, the 10 series did for certain...
The thousand series had a snap/bang engagement
That said, feathering depends more on how you engage the lever than anything else. Even a 10 series can be pretty sharp if you haul the lever ahead fast...

Rod
 
No. The featherable design did not appear until the 10 series came out in 1981. The hundred series were actually among the most violent of the engagers in my opinion. One of the reasons the old 5000s appeared to be soft start is because the pump flow was so low compared to newer models that had the DP option.

As Rod said, to get a feathered start on the 10 series, you had to move the lever ahead slowly. A quick movement got a hard start.
 
RodInNS , you were right. We found the leak and it was in the clutch pack that we put in. We've had that transmission out so many times I've asked the mechanic to put a zipper in it to save time turning bolts. Thanks for everyone's help. Now I'm taking my problem up with the company that sold the clutch pack to me.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top