Sherman High Low input shaft

[600ford]

I have a Sherman in an NAA & want to put it in a 641
I would like to trade my input shaft for one that will fit the 01 series tractors. Any advice or help will be appreciated Thanks

 

[jimNCal]

Easy enough.....send me an e-mail......I have several nice ones. $20 bucks will cover shipping both ways.

jim

 

[600ford]

Here is a photo of the 2 kinds of input shafts the one on the bottom is the one I want & the one on the top is the kind I have. My cell # is 903 513 3261 If you want to call me, if not send me your phone # & I will call you tomorrow.
Thanks
Richard Williams
Alba Tx
Alba is 75 mi east of Dallas

 

[jimNCal]

Yep....that's them. I sent you a private reply also. Notice that the housings are different, and need to be swapped as well. These easily fit into a USPS Medium 'Flat-Rate' box for about 11 bucks. The one I'll send will already have had the input seal replaced.....I buy them a dozen at a time....

jb

 

[jimNCal]

ps......don't forget that the handles need to get swapped also.....jb

 

[rfuchs]

I got a combo that needs the 10 spline input shaft and cone. Do you have any?

 

[rfuchs]

I got a combo that needs the 10 spline input shaft and cone. Do you have any?