Sickle bar mower

[Devon1404]

I?ve tried to post in the help identify portion of this forum, can?t seem to load pictures there. I think this mower is made by Schultz, I need a belt and driven pulley for it. Can anyone help?

 

[ET]

If you can't find a replacement pulley I would just run the one with a chip out of it. It's not perfect but it should work ok.

 

[Devon1404]

Thanks, I was planning to do that if I couldn?t come up with one. I?m hoping someone has heard of this machine and knew where to get parts for it.

 

[Farmallb]

Id take it to a weld shop while it was still on the trailer, and have them build up the broke out piece with cast rod. you can find that belt at NAPA, Or they can get it for you. That belt, just by looking at it will cost you round $50. Be a shame for it to get to looking like the belt in the pic, WHICH MIGHT have gotten cut on the pulley. Shouldn't cost $25 for somebody to weld up that notch and smooth it down. You could do the smoothing with a grinder.

 

[Destroked 450]

Looks like a common pulley you can pickup at a bearing or electric motor shop.

 

[Devon1404]

I might have to give that a try. Thanks!