Solar Panel

I have a 3w solar panel hooked to a 12v 5 amp hour battery.
The draw on the battery is so small it should last 3 or 4 weeks with little to no sun.
But the battery went dead.

I charged the battery with a plug in maintenance charger and it worked as it should so I do not think the battery is bad.

Is there a way to check this solar panel to see if it is charging the battery ????
I am trying to figure out if I had a bad connection or is the panel not working.
 
(quoted from post at 18:50:07 03/13/22) I have a 3w solar panel hooked to a 12v 5 amp hour battery.
The draw on the battery is so small it should last 3 or 4 weeks with little to no sun.
But the battery went dead.

I charged the battery with a plug in maintenance charger and it worked as it should so I do not think the battery is bad.

Is there a way to check this solar panel to see if it is charging the battery ????
I am trying to figure out if I had a bad connection or is the panel not working.
nsert an ammeter (probably milli-ammeter, since 3w/12v is only 250mW. It will show charge current.
 
I've checked them with a volt meter not connected to a battery and it would have, best I remember, up around 20-25 volts in direct sun.

But once connected the voltage would drop to what the battery voltage was.

This was a very low wattage charger, so I wasn't expecting to see much if any instant change in the battery voltage. But it should bring it up over a period of time as long as it was in the sun, a good battery, and no or a controlled drain not exceeding the charge rate.
 
Thanks Steve
The manufacture stated the solar charger is big enough to maintain the battery and its controlled drain with 2 hours of full sun.

So you saying a volt meter hooked to the wires coming from the solar panel should show voltage without the battery hooked up.
 
John in la,

With that small amount of current flowing, it would not take much of a bad connection, and a voltage drop to stop the current flow.
I would have everything hooked up, and start checking for a voltage drop. You can put your volt meter in the amp setting and check the charging amps. But you already know that the battery is not receiving a proper charge,

Guido.
 
An adequate correct charging source (has to be higher voltage then battery DUH) will cause battery voltage to rise and charging current to flow INTO the battery. A low range ammeter in series or a voltmeter in parallel with the battery can provide an indication of charging. An only 3 Watt panel isn't going to set the world on fire.

As an example, if charging voltage for a 12 volt battery were lets use 13.2 volts and the energy source was 3 watts, 3/13.2 = only 0.227 charging amps. AND THATS IN DIRECT OVERHEAD BRIGHT SUN !!!!!!!!!!!!

Solar panels have a power (in Watts) and nominal voltage rating (such as 12 or 24) and a Vmp such as 18 to 36. A voltmeter on the output will show you the volts out of the panel but that open unloaded voltage reading ONLY doesn't tell everything as its power under load that really matters. A Solar Charge Controller takes the raw unfiltered unregulated solar panel output and converts it into the proper charging voltage suitable for the battery.

NOTE the max solar output is when the sun is direct overhead but when at an angle its reduced dramatically based on the angle.

NUFF SAID

In my RV since I usually dry camp off the grid I'm running 1080 Watts of Solar and 412 Amp Hours of Lithium Battery energy storage with a 2000 Watt PSW Inverter. That allows me UNLESS ITS RAINY N CLOUDY DAYS ON END to power up morning coffee, instant pot, microwave, hair dryer small 120 VAC fridge, fans, water pump, electronics and RV loads INDEFINITELY yayyyyyyyyyyyyy

John T Dry camped in Cape Canaveral FL runnin off solar
 
But you already know that the battery is not receiving a proper charge
With that small amount of current flowing, it would not take much of a bad connection


Thanks Guido
Now that makes me think about this more.
I really did not check the charge of the battery.
I just assumed it was not charged.
I removed the battery; placed it on the charger; and reinstalled the battery afterwards.

It could be as simple as a bad battery connection that was cured from me taking the battery out and putting it back in.
 
John,

You are welcome!. Now you know for the next time you tackle an electrical problem.
Get the volt meter out, and go at it!

Guido.
 
John T

This is a very small; crude and cheap system.
No Solar Charge Controller
Just a solar panel hooked to a battery then from battery to a actuator.
The draw is only about 1.5 amp hours per week.

I realize a volt meter hooked to the battery should show higher voltage with a power source connected.
The problem is the difference between battery and charging battery voltage is going to be so small I was afraid of not being able to notice the charge on the meter.

Hence the reason I was looking for a differant way to measure charging.
 
With a battery of that capacity operating a gizmo that is on momentarily and periodically 3 watts for about an hour of 90 degree angle sun. should work. The cell array should be about 8 inches square or more. Battery voltage when charging in full sum may only be 1 volt above charged battery voltage. Maybe less. Jim
 
As I remember my solar panel put out about 20 volts when not hooked to a battery, I don't remember if I ever checked the battery with it hooked up, but it worked well. I had 12 volt lights and a TV in my fish house out in the middle of the lake.
 
Hi John, no problem, if a voltmeter doesn't work well for your situation, then take my other advice and place a low scale ammeter in series between the panel and battery EASY PEASEY

Take care now hope this helps

John T
 
It's been stated but the 3W panel rating is best case scenario, you might only see half or less of that output averaged throughout the day of light. A 3W panel is only providing 0.25 amp of power at best, this is more than likely not enough for a 12V-5Ah battery. Even if it's charging the battery somewhat, it would take more than a full day of sunlight to recharge the battery, even when the battery is 75% full.
 
(quoted from post at 17:03:35 03/13/22) John T

This is a very small; crude and cheap system.
No Solar Charge Controller
Just a solar panel hooked to a battery then from battery to a actuator.
The draw is only about 1.5 amp hours per week.

I realize a volt meter hooked to the battery should show higher voltage with a power source connected.
The problem is the difference between battery and charging battery voltage is going to be so small I was afraid of not being able to notice the charge on the meter.

Hence the reason I was looking for a differant way to measure charging.

Frankly I would not even waste my time trying to figure it out. As has been pointed out 3W is almost nothing in full bright sunlight. You need a much larger solar panel to maintain this battery. 15W, 30W.

Also, "charge the battery and it works so it's not the battery." Not so fast there... A bad battery will appear to take a charge and may even have capacity to work immediately after it has been removed from the charger. The real measure of a good/bad battery is if it will hold that charge and for how long.

A 12V battery sitting disconnected should hold an appreciable amount of its usable capacity for months, even years. After a day or two it should not be noticeably discharged.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top