Mike (WA)

Well-known Member
Tried searching the site, but didn't come up with what I wanted. Have a couple of seldom used gas engines, and kind of got crossed up on whether I had treated the gas with Stabil or not, so now they are varnished up. Someone on here awhile back said you could add either acetone or MEK (methyl ethyl ketone) and it would migrate through the line to the carb and free it up, without having to remove or disassemble (presumably after draining and replacing the bad gas from the tank). Anybody remember what it was?

And how about Stabil- heard some disparaging remarks on here about it- are some other products better? Thanks- Mike
 
acetone will clean up the varnish, but if it has been sitting a while, maybe drop the carb bowl and flush it out good. i helped a buddy last nite work on his yamaha 4 wheeler carb, had stabil in it last fall. when the bowl came of the carb, it was full of a jelly like snotty stuff. must have had water or something in the fuel and got a bacteria growth in it.
 
I'm not sure either one of those works on gasoline varnish.

If the engine starts and runs or at least fires, I spray a bunch of carb spray in the tank with little or no gas. If it runs, I may also pour some fuel injection cleaner in with the gas.

If it doesn't run, drain the gas and spray part or all of a can of carb cleaner in the tank. Crank on it for a while and the carb cleaner will get down to the carb. May want to drain the lines and carb bowl first and spray into the lines and carb directly. Let it set for a while to clean the varnish out of the tank bottom, lines, and carb.

I'm rebuilding a 2 stroke trimmer engine and use carb cleaner. Someone on a forum said to use starting fluid and not carb cleaner since the cleaner eats up the gas lines, primer bulb, and the diaphram rubber. Don't know for sure on that but I use carb cleaner all the time on small engines. On those 2 stroke and old engine carbs with diaphrams, the diaphrams tend to dry out and get gunked up anyway and need replacing every so often.

On the other hand, I usually forget to put stabil in the mowers and they still fire up first time in the spring. If you have a varnish problem, change the filter also.
 
IF you can get them to run, put a little "sea foam" in the tank and run it a little while! Sea foam is MUCH better than sta-bil IMHA
good luck
 
While I like alcohol blended gas - it doesn't store well. Most likely that's what he had in his tank when he parked his 4 wheeler last fall. Untreated gasohol jells up like that in a winter's time but usually stabil will prevent it. But then I always use about 3-4 times as much as what the bottle says.

I don't know how well Seafoam works at preserving gas but it does a great job cleaning out partially gummed up carbs in small engines(again I use about 3X what the can says).
 
Two problems with that idea: First, there's no way for the solvent to penetrate into blocked passages; you need to dismantle the carb and clean them out with a piece wire or possibly compressed air. The second problem is that MEK will wreck any rubber parts it comes in contact with. It's fastest and safest to take the carb apart.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top