Starter wiring

jaoneill

Member
Received the new starter for my Allis 6070 yesterday. Tractor has a single wire from the "start" on the key switch to the solenoid. New solenoid has two spade connectors, not one. Is this going to require additional wiring?
 
First make sure this is the correct replacement starter. If that is verified look for a S ID on one of the spade terminals, that
is the one to connect the small wire to. If that ID cannot be determined install the starter, connect the battery cable and
MAKE SURE THE TRACTOR IS IN NEUTRAL. Then take a screwdriver or other suitable metal object and jump from the
battery terminal to one of the small terminals which ever one cranks the engine then that is the one that needs connected
to the small wire for the start circuit.
 
Thank you gentlemen, those were my thouhts but didn't want to screw up the solenoid by getting the wrong one. (I'll look for the "S", that would make it very simple)
 
laoneall,

As someone said, that
S is the power from
the ignition switch, the other lug is
the ground.
If you do not have another wire, you will
need to wire the other terminal to ground.
That is an externally grounded solenoid
switch.

You can run the ground wire to the
mounting bolts,

Guido.
 
If the second small terminal on the solenoid is marked with a 'I', it is not an 'externally grounded' solenoid. That terminal is to give a full voltage to the coil, bypassing the resistor, when starting.
 
They do not appear to be labeled but I would assume that the one that is fastened with a copper rivet would be the (+) and the one fastened with an aluminum looking rivet is the (-) ground.
 
jaoneill,

Just provide power to to S terminal and
see if it starts. You then will know which
way to go,

Guido.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top