Starter

[Bob in Tennessee]

I had trouble removing a starter and ending up letting the armature separate from the brushes. Any tips on getting the brushes secured so i can reinstall armature?
thanks

 

[Bruce (VA)]

Yea, that happens when you forget to put a nut on one of the starter bolts .

See tip # 36.

There are plenty of ways to put the starter back together. Some folks use alligator clips, toothpicks or dental floss to hold the brushes back. Others remove the metal band and paper gasket, then put the starter back together. Pull the brushes up thru the holes that the band was covering. Use long nose pliers to pull the brush springs up. Move each one to the right and let them rest on the brush holder. Put each brush into the holder. Pull up each spring and place it on each brush. Put the gasket and metal band back on.
75 Tips

 

[Bob in Tennessee]

Thanks Bruce! I am assuming I will need to wedge a toothpick between the brush holder and brush with enough force to prevent movement.

 

[Hobo,NC]

Quote Bruce

Use long nose pliers to pull the brush springs up. Move each "SPRING" to the right and let them rest on the brush holder. Put each brush into the holder. Pull up each spring and place it on each brush.

Don't overthink this its simple as pie...

The same deal ford starter he uses a hook tool to lift out of the way.

https://www.squarebirds.org/simplyconnected/390Build/FE_StarterMotor.htm

pix found on the net

 

[Bob in Tennessee]

Thanks Hobo!

 

[gary-ca]

Hi Bruce, what is the best way to remove the starter? Maybe use a putty knife to help separate a stuck plate from the bell housing?
Gary