Steering knuckles

[4430]

How do I remove the steering shaft on a 930 Case ?

 

[1031D]

You need to remove the steering wheel, remove the pin from the u-joint in the front tub, unbolt the bearings and pull the shaft out. Then remove the steering wheel and pull the shaft out.

 

[4430]

In the front knuckle down by the steering motor there's a roll pin but I can't see any on the back side of it

 

[1031D]

There's a roll pin and key on each yoke, remove the one away from the gear box, kind of hard to get in there but a good excuse to wash the years of goo out.

 

[4430]

Thanks
I was wanting to remove the front to do just that to clean it out and repaint before putting the rad and power steering back in