Styled A seat parts

[Elbrus]

I am finishing up restoring a 48A and am looking for two parts to the seat. They are the pin A3335R and the spacer B2671R. They appear to be simple parts, although I never have seen them because they were not on the tractor when I started. I am hoping someone maybe has dimensions of these parts so that I could just make a set.
Thanks in advance for any help
WIG

 

[James Howell]

Take a look at the photos below of the seat adjusting pin and seat adjusting pin spacer.

The diameter of the seat adjusting pin is approximately 1/2 inch.

The seat adjusting pin is approximately 3 inches long.

The seat adjusting pin spaces is approximately 3/8 inch long.

There is a cotter pin securing the spacer to the pin.

The pin sticks out approximately 1/4 inch.

Hope this helps.

 

[Elbrus]

Thanks James.
This was very helpful. Not that it's critical but more from authenticity, what is the approx OD of the sparer
Thanks again
WIG

 

[James Howell]

Pure speculation on my part, but my guess would be about 5/8 - 11/16 inch OD.