styled A tool box fit

[wigfimml]

Anyone have a picture of a styled A SN 584000-655193 tool box mounted in the front frame? I appear to have an interference with the screw/nut that holds the fan support on. I"m quite sure I have the right box, but without trimming it in that specific area it will not fit. A picture mounted in the frame would really help before I do that.
Thanks
WIGFIMML

 

[1949ABG]

The cap screw that holds the fan support also runs through the top hole of the tool box.

 

[Len Bull, New Haven, VT]

My late 1950 A has it mounted in the left front, flywheel side, attached to the fan mount frame as was noted. My parts catalog shows it as mounting on pulley side, but has two box listings (584000-655193) and (655194-). I suspect since my tractor is SN 666598 that it is the second, and that probably is a left side mount although not shown in the catalog that way .
The bolt is 5/16 x 3/4 as shown. Page 5 of my catalog, PC675.

 

[BushogPapa]

Yes, JD finally Wised-UP and moved it to the Flywheel-side..!!!
Man, that Exhaust Pipe gets HOT...!!!

I think EVERY old JD owner had a bad BURN from reaching for a wrench and getting into that exhaust pipe..!!!
Ron..

 

[DScott]

(quoted from post at 03:46:51 05/21/12) My late 1950 A has it mounted in the left front, flywheel side, attached to the fan mount frame as was noted. My parts catalog shows it as mounting on pulley side, but has two box listings (584000-655193) and (655194-). I suspect since my tractor is SN 666598 that it is the second, and that probably is a left side mount although not shown in the catalog that way .
The bolt is 5/16 x 3/4 as shown. Page 5 of my catalog, PC675.

Len,
I have #666938. That's pretty close. I don't know the history as far as where it was originally sold and etc. I bought it in east Tennessee a couple of years ago.