Super C front end

JustahobbyMn

New User
I have a narrow front (two wheels) super c that I have
almost entirely rebuilt front to back. A few months ago it
developed an intermittent clicking as a go forward. Front
rims were replaced awhile back and tires are very good, I
replaced them about ten years ago. Wheel bearings were
done a few months ago as well. Any ideas what it is?
Everything is tight. Steering maybe?
 
Dont neglect the rear wheels either.Look for signs of movement/wallering.There will be chafed paint,a telltale sign of movement.Loose wheel weights can also male clickimg/clunking noises.If noise continues after wheels/weights are checked and tightened,then you may have a transmission bearing failing.
 
My c front , have inner races that worn into the hub .03+ , over the years. So, if the you jack up front wheel then you can grip top of front wheel and bottom of front wheel and try to push and pull it quickly .if the wheel move in and out ,the hub is worn ,nothing is holding the inner race. the clicking ,of clunk noise resulting from loose race.
Suggest removing the hub off front axle . Remove inners race which is loose. Clean out grease..clean with brake cleaner. Mix up some JB weld , coat just enough in worn hub all round worn area. and press inner race in complete till stops on hub ,wipe away excess JB weld with paper blue scott to clean any off race. Let it set up over night . Next day (24 hours later ) put wheel hub back together and reset the bearings with spindle nut.
Anyways that may be the noise you hear
 
If you are going to the trouble to pull the front wheel and remove the races, go down to the parts store with the old races and bearings and get some new ones along with new inner seals. Have we totally lost the art of replacing wheel bearings? It has to be done now and then. To get the grease packed into the new bearings try heating them up a little like 150 to 200 degrees and rolling in the grease . . . unless you happen to have a bearing packer tool. I don't and you do not need one, but you will need to be patient and roll every bearing until coated with grease that is wheel bearing grease sold at most parts stores. By the way do not attempt to replace part of a wheel bearing set and not replace everything including both bearings, races and the inner seal. These parts were made to be replaced when worn.
 
REMOVE the bolts holding rim to the center lube up the threads and nuts put em back super tight and your click will be gone
 
Good advice on the back end too. My son was tailing me across town and told me one of the wheels had a wobble to it and it was a loose axle bolt. It would have taken a while for the wheel to work its way along the 12 inches of excess axle, but I am glad he saw it.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top