Surging idle on John Deere M

gewart

New User
I have 1952 John Deere M my problem is with the idle it constantly surges up and down.The linkage running from carburetor to governor move back and forth with idle surge all external springs are in place. Any help will be greatly appreciated.
 
First, check length of governor-to-carb rod.

Simply put, the carburetor throttle butterfly lever should reach it's "end-of-travel" in the "open" direction JUST BEFORE the governor lever does.

If that's OK, it sounds like a carburetor problem, in the idle or transfer passage area.

Governor throttles it to idle, carb doesn't flow enough gas through idle circuit, engine slows down, governor begins to open the throttle, engine continues to lose speed until the governor has opened the throttle enough for the "load" circuit to begin flowing, engine quickly accelerates, governor closes throttle, and the idle circuit doesn't take over, and the cycle repeats.

Could be some passages not completely clean/open, or a leak at the gasket between the upper and lower bodies, or even issues with the venturi, needs to be undamaged, correctly installed, and the gasket surrounding it needs to be intact and sealing.

Also, with carb removed, back off idle speed screw and observe if throttle butterfly is centered in the throttle bore, and closes evenly all the way around.

If not, the screws can be loosened and the plate shifted around a bit 'til it is. (Screws may be "staked" at thread end, don't mess with them unless adjustment is needed, and deal with them appropriated to avoid breaking them off.)

(Having the plate centered helps the idle passages and transfer circuit work as it's supposed to.)
 
I would start by turning the screw on the top of the carb out some. On my mt it was doing the same as that and I had to turn it out about a 1/4 to 1/2 turn and it runs nice at idle. The bottom one on them carbs is the load screw for hard pulls. Let us know on how u do and we will help.
 
Lean mixture. The idle screw on those works just backwards to most. Turning in richens it up and out leans it. It is an AIR control screw....not fuel control. Isay your issue is worn out throttle shaft/bushing. Letting it suck air around it and not fuel from passages. Slowly close choke a little and see if it smooths out. If it does...it's starving for idle fuel OR sucking too much air Throttle shaft worn out.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top