T340 Rollers

[DozerD]

I have 7 replacement rollers for a t340 crawler. They are BERCO IN-2554 (could be IN-2664)....does anyone know if these are right for the machine. Also they are all seized, might it be as easy as taking them apart and lubing them up good then putting them back together or am i dreaming? I am new to crawlers...Last question for now...will it matter if the 8th roller is not identical to the others? Thanks

 

[Charlie]

Since no one else has replied I'll give my two cents. You seem to have the early model with 4 rollers per side. Re: fitting, you need to check first the bolt pattern, then the diameter, and then the width. Do you have old rollers to use for comparison? Now, regarding the seized rollers, if they are not warn but just seized up from long term storage,you should be able to get them going. It's hard to get rollers for this machine. People are always looking for them. You could take out the plug at the end of each adn see if there is oil in them. There should be. If so, that's a good sign that they are OK.

 

[DozerD]

thanks for the reply, do have old ones to compare, and in the mean time i got all but one rolling...may need to soak alittle more overnight. I will compare the rollers. If I used one that was more worn than others would it be best in the middle and not the ends or is there a better spot for the most warn? Thanks

 

[Charlie]

I would always have the best ones on the ends. I would put the weakest one next to last on a four roller system.