test

[roney7]

I put air pressure to the Case 450B torque converter and got air bubbles comeing out Looks like I will need a new o Ring This was a new one I put in but it still leaks . It was the large O-ring on the inpeller . This was eaiser that reinstalling the torque converter and the pulling it back out. Better luck next time on it

 

[roney7]

Looks like I made have had the O-Ring side ways . I rolled it this afternoon and will test it again tomorrow. If I could put it back together correctly as easily as I take it apart I would be doing OK.

 

[AJ.]

You must get the o"rings in place without any twists in them,if they are twisted they go thin at that point and will leak,go by your tire shop and get some lube they use for tire fitting,it will hold the o"rings in place and help them to slip in.
Good luck
AJ