TO20 Three point lift problem

[jbaker0725]

Having a problem with the three point lift. It will not lower. Stays in the up position even when you turn the lever to lower it. Any ideas on what the problem could be?

 

[keysem]

Check out the comments at the following link for this issue.
http://www.fergusonenthusiasts.com/restoration%20helps/tech/Lift%20Arms%20Stuck%20in%20Up%20Position.pdf

 

[Jerry/MT]

Either the control valve is stuck or the control valve has come off the control fork.

 

[Kevin OH]

mine did that on my te20.the only way it would go down is to shut the pto off.i couldnt see a leak any where.i took it all apart and the only thing i found is that the ring on the end of the piston was broke.i got lucky i went ahead and put a new cylinder,piston and rings.it works now