To30 engine rebuild

[[email protected]]

Hi guys,

I am rebuilding my Ferguson to30 and when I went to install the new valves I noticed that the exhaust valves do not have the dimple in the top to accept the caps with the little pin on them. The old ones did. The intake valves do not have the dimple so the caps just sit on top. My question is, can I just use the same caps as the intake valves for the exhaust valves.

 

[Ericp351]

FIRST- measure length, new with out cap vs. old w/ cap. I do not know what you bought, but revised design may not need them. Better still- ask vender. If he
can't answer- you got a bum! (Obviously I worded for family/ mixed company Web Sight.) Rock on....

 

[[email protected]]

(quoted from post at 12:30:36 04/29/23) FIRST- measure length, new with out cap vs. old w/ cap. I do not know what you bought, but revised design may not need them. Better still- ask vender. If he
can't answer- you got a bum! (Obviously I worded for family/ mixed company Web Sight.) Rock on....

Thank you! Never even thought to measure them. The new ones are the same length as the old ones with the cap.