Today's funny

[jon f mn]

.

 

[plowhand]

Par for the course

 

[dleefarms]

Or worse - you find out it's not the bolt you needed loose.

 

[stevob671]

...and you hear something inside go Clunk!

 

[showcrop]

I worked at one nut for a half hour yesterday. No rust, just no way to get enough wrench on it but I finally figured it out.

 

[grizz02]

or your turning it the wrong way with an impact wrench SNAP

 

[Janicholson]

Or you realize it was a hexagonal boss on the casting made to look like a bolt head by a nasty engineer with an artistic flair that made a complete bolt pattern using it. Jim

 

[Rich'sToys]

(quoted from post at 06:36:57 03/10/20) ...and you hear something inside go Clunk!

 

[Goose]

I know the feeling.

I was once torqueing the connecting rod cap bolts on a 350 Chevy engine on an engine stand. They were suppose to be torqued to 35 ft/lbs. One of them snapped at 30.

Needless to say, I started all over with all new bolts.

 

[Ellis Kinney]

Trying to remove the brake bearing/seal cage and all of a sudden a sickening pop. Ellis

 

[Janicholson]

I remember well your issue and wish it never happened. Jim

 

[T in NE]

N14 air compressor bolts.
Need a gear wrench with a 90 degree bend at
the box end. And another bend a bit farther
up.

 

[EliG]

My patients does not last that long after about 15 minutes out comes the torch. It can't be stuck if it's a liquid!

 

[SVcummins]

Cummins Bosch ve injection pump bottom bolt without the special wrench

 

[SVcummins]

How I?ve never been struck by lightning I don?t know