toe in question on 2N ('46)

ronboy

Member
I hit a hidden stump while bushhogging the other day. Front wheels were way out of alighnment. I adjusted both drag links to get best possible combination, that being both of them screwed all the way up to try to bring toe in in. Both wheels have pretty severe toe out. From past forum discussions om toe-in subject, I checked all (tightness, steering response, etc) and all seemed normal. I hope its something simple, but I fear its not. I'd appreciate any ideas from you kind forumites. Thanks.
 
The standard setting is 1/4" (toed IN). It seems likely that you have bent something (hard to see visually). Use a straight edge or a TIGHT piece of string to check the rods et al. HTH
 
I have done the same thing... except I didn't fool with the tie rods (It's not THEIR fault, they don't change!!!)

I just loosened/removed enough stuff to access all the sector bolts, removed them and raised the sector up about 1/2 inch. Then I re-set the toe-in manually, Then lowered the sector half again & reassembled. The hood will accomodate that much lift.

Works fine, last a long time as they say... '46 2N

duey
 
Thanks all you guys for trying to help first of all. I've been messin around with it this AM. What I found that could shed some light on the problem is this: sector arm on right side (the side that has the gas throttle lever on) has 1/2-3/4 inch play before it engages steering wheel. The other side sector arm engages immediately. Bob: all rods seemed to be in good shape (straight) Soundguy: jacked up front and did full steering wheel turn slowly and seemed normal. Madfarmer: 1/2-3/4 inch play on the the sector arm but not the other. To be continued.
 
Duey: Please realize I'm am amateur at this project and appreciate your guidance. Soundguy and Madfarmer kind of thought jumped/skipped tooth (does that 1/2-3/4 inch indicate that?). If so, I'll need more details removing sector bolts and raising sectors up 1/2 inch and other details in the process. I've pored over my two manuals and still don't understand. Sure would appreciate any more help from any of you guys. Thanks.
 
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top