(quoted from post at 06:54:47 11/29/21) > If I stand on a 1 ft breaker bar, I would get 190 #ft.
And possibly a broken nose when you slip off, George. I don't want to see you or Stan hurt. The rule is always PULL on a wrench.
(quoted from post at 10:20:06 11/29/21) 180 ft-lbs is a bunch. I would torque to 150, then switch to a breaker bar and give it a little extra.
To get 180 ft-lbs on an 18 inch breaker bar will require at least 100 lbs of force. I don't think you need to worry about over-torquing. I would not use loctite in this application.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy