Transmission Problem

[IDKWTUAMUN]

I have recently installed teh shifter lever om Super 88. I am having a hard time getting it to go between the two ranges. Occasionally, after trying long enough, it will go and them it works fine in the other range. Is my shifter lever misaligned some way? How can I fix it?

 

[tom upton]

Any chance you lost one or both of the springs that center the shift lever to go between upper and lower?

 

[IDKWTUAMUN]

I’ll check but I don’t think so…

 

[Centerplate]

The springs should return the lever to the mid position on the 'H' pattern. Check the springs if you have not done so.

Spitballing here... do you have enough oil in the transmission?

 

[Gary Mitchell]

I’ll check but I don’t think so…

You can hold up on the shifter while changing gears. If it works that way, you've probably lost balls, springs, etc into the transmission. Best get em out of there. Outside chance the detent balls on the front of the rails need lubrication. gm

 

[Saskoliver]

I’ll check but I don’t think so…

What have You discovered?

 

[IDKWTUAMUN]

I haven’t had time to do anything with it yet… But I will let you know when I do figure something out.

 

[IDKWTUAMUN]

Springs were fine and in place.
To my embarrassment, I took the top of the transmission and it was only a maligned gear. It would have moved into position when I started the tractor.

 

[J.Wondergem]

That's good to hear.

 

[rrlund]

Springs were fine and in place.
To my embarrassment, I took the top of the transmission and it was only a maligned gear. It would have moved into position when I started the tractor.

OOPS!

 

[Saskoliver]

Springs were fine and in place.
To my embarrassment, I took the top of the transmission and it was only a maligned gear. It would have moved into position when I started the tractor.

Well, if anything you got a Look at the Condition of the Gears!

 

[IDKWTUAMUN]

Yes, but I wasn't really wanting to look at the gears... Thank you all for all your responses!