Trojan wheel loader model 164

[TiredIron#3]

Need help power steering pump not working looking for replacement also cannot figure out how to reach oil drain plug size? New to me loader

 

[sandcastle1]

For the power steering pump some forklift shops might be able to help you with parts.

 

[used red MN]

also cannot figure out how to reach oil drain plug size? New to me loader

Hello TireIron.., welcome to YT! No idea of the configuration of the machine you are working on. A picture of it would be extremely helpful!! Here is a possible idea, duct tape a large enough socket onto a long extension. Place a sufficient amount of modeling clay in it and sprinkle talcum or baby powder on the exposed surface of the clay. Shove the socket over the plug to make an impression to measure. If the plug is oily the powder can probably be skipped.

 

[TiredIron#3]

Hello TireIron.., welcome to YT! No idea of the configuration of the machine you are working on. A picture of it would be extremely helpful!! Here is a possible idea, duct tape a large enough socket onto a long extension. Place a sufficient amount of modeling clay in it and sprinkle talcum or baby powder on the exposed surface of the clay. Shove the socket over the plug to make an impression to measure. If the plug is oily the powder can probably be skipped.

Thanks guys I’ll try to get some pictures

 

[TiredIron#3]

Hey guys, me again. Trojan 164 , I had the carb rebuilt, however the fella that rebuilt it was just killed in a motorcycle crash, I do not know what initial carb settings would be. Any help appreciated it is a 1959 with a 6 cylinder Hercules gas engine also could someone tell me how to post pictures I haven’t any idea how to do this

 

[used red MN]

Do you know what brand the carburetor is? On the pictures in the reply box use the photo icon at the top, when you click that it will open a window to access the photos in a file. It may say “Drop Image” on a phone or tablet, if you click that it will let you select photos from the storage. You can also use the “Attach files” at the lower left.