under axle brackets

[Ultradog MN]

Does YT sell these brackets? I couldn't find them.
I need a link to where they are in the store.
Thanks

 

[dont_know_a_thing]

Stabilizer Kit, Extra Heavy Duty Part No: 231253XHD

Stabilizer

 

[dont_know_a_thing]

That is from this site. Tractor Supply sells them also...

 

[boler76]

Probably hire a good mechanic and he could make some out of angle iron and a couple hard bolts and all your problems would be solved QED

 

[Paul in MN]

U-D,

Fleet Farm has them at reasonable price, probably cheaper than TSC, and closer to you (Brooklyn Park store). They are usually sold with the stabilizer bars, but they are not very stout bars.

From my perspective, they are not worth the cost or aggrivation of putting on something that is not just quite right. The last 2 pairs of angle brackets I needed, I made myself. I use the power bandsaw to cut 3/8" or 1/2" thick angle and the drill press to make the holes. If you want a quicker job done, then the plasma cutter is the ticket, and does a respectable enough job. I have store bought samples to work from, but for a Jub or 600, I'd bet the design is a bit different than the 8N.

Give me a call.

paul

 

[Ultradog MN]

Thanks Paul.
I was trying to help a fellow find just the brackets for his Dearborn/Danuser PHD and wanted a link.
On a side note:
You planning to meet for a burger and beer with us?

 

[Paul in MN]

U-D,

Look for an e-mail. I wanted to take this discussion off line.

Paul