update on tying with pic

[steven in Tn]

heres the picture of the first bale ever made with this bale pretty happy with it,just have a question on the tying.
are they anything i can to help with the twine falling off the bales after tying and dumping the end is just hanging and falls off and gets ran over when moving them?

 

[donjr]

Nothing short of tying each end by hand....

 

[IBorangenTX]

Steven,
Don't know what type of rd baler you are using, but to help with your problem, when baling fill each side constantly, don't worry about filling the middle. It will take care of itself. Set your pressure on the bale to about 5, maybe 5.5 and the baler will fill the chamber to that point. While you are filling the chamber, weave your tractor slowly from side to side of windrow. Lot's to learn about a baler. Each baler has it's own personality.
Hope this helps

 

[jon f mn]

Don't tie so close to the edge. Stop maybe 4-6" further from the end, this will allow the edges to expand a bit holding the twine on the bale.

 

[Ken Macfarlane]

You can nudge them so the loose piece doesn't fall down. If you have 4wd don't let it get into your planetary seals.