VAC Case Magneto Pin Sheared

[M5G]

My VAC magneto pin sheared and dropped down onto the camshaft gear taking out some teeth. I removed the front engine cover and exposed the gear but I can not figure out how to remove the gear. I got the nut off but the gear won"t buldge. I tried jacking up the rear wheel and putting it into gear and find that it doesn"t turn the gears. I thought it would turn the gears and possible something was binding the gear. Once I get the gear off; I will be in need of a 24 tooth VTA-402 Mag drive gear and the VT-127 camshaft gear. My tractor serial # is before 5365687. Any and all assistance is appreciated.
This VAC has been in the family since original purchase...therefore I"d like to keep her going.

 

[1031D]

The cam gear is pressed on. It can be removed with a 3 jar puller. If your tractor has the flyball governor I would highly recommend replacing it with a flyweight type, used in later VAC's up into the 30 series. The magneto gear can be sourced from someone like Browning, or perhaps someone has a good used one.

 

[Joe (Wa)]

Go to the link and read up on Camshaft. Click on page to enlarge for reading.

Joe
VA service manual

 

[M5G]

Thanks for the input. I appreciate it.

 

[mj]

(quoted from post at 10:30:20 05/21/13) Go to the link and read up on Camshaft. Click on page to enlarge for reading.

Joe

Hey Joe -

Somehow that link works but is a bit round-about so here is the one I think you thought you had or ...... :roll:

http://imageevent.com/skipjack/vamanuals