W-4 Wheels.

[Ohio-H]

Just picked up what I believe is a "43" W-4 (cast iron shift knob) on what I think are steel spoke

cutoffs in 24" rims. Am I correct or were some built this way?

 

[rustred]

Just picked up what I believe is a "43" W-4 (cast iron shift knob) on what I think are steel spoke View attachment 114447cutoffs in 24" rims. Am I correct or were some built this way?

both the front and rear are cutoff's thm front tires look too big. should be 600x16 on the front. rear should be 14.9 x 26 its sitting way too high in the front.

 

[BarnyardEngineering]

The wheels weren't cutoff from the factory. Wartime tractor, so it was originally on steel wheels.

 

[Ohio-H]

both the front and rear are cutoff's thm front tires look too big. should be 600x16 on the front. rear should be 14.9 x 26 its sitting way too high in the front.

Front tires are old truck tires, about 5" taller than 5.00×16's I have.

 

[BarnyardEngineering]

Front tires are old truck tires, about 5" taller than 5.00×16's I have.

As I recall, the original rubber tires on early models were 24" on locking ring rims. They went to 26" so they could have a one-piece rim with a drop center. on the same hub.

 

[abuelo]

The welds between the spokes and rims do not appear to be factory .

 

[Ohio-H]

How plentiful are the correct wheels-rims

 

[rustred]

How plentiful are the correct wheels-rims

I have the correct wheels rims on a parts tractor. Even if you put 600 x 16 on the front instead of them 750’s would smarten it up. And a set of fenders. That is so wrong.

 

[Ohio-H]

I have the fenders, I intend on using it for tractor rides, so probably turf tires on the rear.

 

[Ohio-H]

I may have you bring them to Georgetown.

 

[Ohio-H]

I have the correct wheels rims on a parts tractor. Even if you put 600 x 16 on the front instead of them 750’s would smarten it up. And a set of fenders. That is so wrong.

How much would you want for them, and where are you located??