Wc Allis

[WD2]

What is the best size tire to run on a Wc Allis with a Gleaner E motor in it? Also Looking for some adapter Plates For it. I will be Running in the 3 Mph Class with this tractor. Thanks

 

[VicS]

There is no best size, that said If you want to pull 3500 and below. probably 13.6 X 38. You could also mount 15.5 X 38(tube less?) on some super light rims and get there too. Mike Bock on this forum runs 13.6 X 38 and he is almost always right up there to the top of the class. It takes a 38 to clear your final drives on a WC to get it narrow.

 

[WD2]

well i found a set of 15.5 38 i was trying to figure out my options

 

[WD2]

Do you know where i might find a set of adapters? Thanks

 

[ph-1]

unverferth makes an 8 bolt stamped steel center looks jus like the 9 bolt style .they were made for irragation systems i was told then u weld the center in rims too what ever width you want or buy em put together

 

[Larry Mc]

Be sure to check the rules where you will pull! Some won't allow 15.5 under a certain weight class.

 

[pipe]

WE HAVE ADAPTOR FOR A WC 6 BOLT TO 9 BOLT $165.00 SHIPPED TO YOUR DOOR

 

[Mike Bock]

13.6 -14.9-15.5-38 all would be good tires on most tracks have seen were 12.4x38 tires that were off of a sprayer and road worn real bad wore very hard to beat has a lot to do with the nut behind the wheel