wheel weights wanted

[realolman]

I would like to buy some wheel weights for a 300 utility ... located in southwestern PA.

 

[IH fan]

Good luck finding them. I watched in the Photo Ads parts section here for about 6 months and found a set for my 240U close enough to go pick them up. they were about 230 or 240 miles from me. They actually came off a B, but was told they would fit and measurements seemed to confirm that. I finally got them mounted just today, before any snow. I pulled the neighbors old cemented in mailbox post out of the ground a couple weeks ago and it lifted the rear off the ground. Maybe it wouldn't do that quite as easy now. That neighbor helped me lift them on today.

 

[realolman]

how about puttin a couple stamps on em and sendin em to me :-D

 

[Dellbertt]

Leader Farm Equipment
Everett, PA

Dell

 

[John - OH]

Looking for fronts or rears. I got a set of fronts I would sell.

 

[realolman]

thank for replying, but i'm looking for rears

 

[pete w]

Will weights from a A work?? What are they worth???

 

[Dellbertt]

You should not have much difficulty finding a set if you have the 28" two piece rims. Just about any IH will fit. I have one set of factory two piece weights with another one piece weight on top. I had the one piece on my H.
If you have the 26" one piece wheel, I don't know about weights for those.

Dell

 

[IH fan]

(quoted from post at 06:38:28 12/09/10) Will weights from a A work?? What are they worth???

I don't know for sure about a 300/350 wheel, but if it is "dished" and 28", with a 9 1/2" square bolt pattern, I think any of the one piece or two piece from an A, B, or 240U and who knows how many others, would work. These I got from a B fit perfectly, and weigh about 75# each.