which overrunning clutch

[GARYAR]

Thanks for the advice on the finish mower post. I have decided to buy orc this will be for 1951 8n with what I belive to have 1 1/8 pto. will tsc part number 0271148 $79.99 work? finish mower has 6 point spline. also is there a better supplier or cheaper I should say.

Thanks in advance
Gary

 

[Dell (WA)]

garyar........modern PTO splines are 1-3/8 dia. Early 8N PTO's are usually 1-1/8" dia spline. ORC's can be had 1-1/8F (which fit the tractor PTO output) and 1-3/8M which fit modern PTO shafts. So you don't an "adapter". Iff'n yer early tractor PTO has been changed to later modern 1-3/8" specs: you can get ORC's that are 1/3/8F and 1-3/8M. Isn't that amazing??? There are many reasons modern PTO's are 1-3/8" since you can NOT buy 1-1/8" PTO parts. Ittza 4-bolt 15-min job to change yer PTO shaft to 1/3/8".

As to whether yer TSC ORC will match, I don't have a TSC catalog on OEC specifications. Yer there and I'm NOT. You should beable to determine yer PTO specs. ........respectfully, Dell, the PTO safety preacher

 

[Tom N MS]

Do as your heart desires but no ORC clutch is needed on a finish mower....and yes that price is too high..

 

[presdme]

Purchased mine from this site. Couldent be happier

 

[Cutty]

Same item as TSC for half the price...exact same item.
http://www.agrisupply.com/-over-riding-clutch-/p/12051/cn/3500000/

(quoted from post at 22:13:57 10/08/11) Thanks for the advice on the finish mower post. I have decided to buy orc this will be for 1951 8n with what I belive to have 1 1/8 pto. will tsc part number 0271148 $79.99 work? finish mower has 6 point spline. also is there a better supplier or cheaper I should say.

Thanks in advance
Gary

 

[Jimmyjack]

Went to local Ford dealer and he said ORCs are becoming harder to buy. Some companys pulled them off the shelf for liability reasons. May be some truth to it.